Manual

Installation Instructions for Rocky Ceiling
904-ROC-C-H2-02
Install the Fixture
1
ROC-C-H2-_
1718 W. Fullerton Ave
Chicago, IL 60614
Tel: [phone]
Fax: [phone]
www.edgelighting.com
[e-mail]
A
1: Loosen and remove the metal shade from the canopy.
#8-32 SCREW
B
2:
3:
the provided #8-32 screws.
Feed the power wires through the crossbar center hole.
Mount the crossbar to the electrical box threaded holes with
METAL SHADE
ELECTRICAL
BOX THREADED
HOLE
CROSSBAR
CANOPY
1
2
3
3
SAVE THESE INSTRUCTIONS!
- This product is ETL listed for indoor and outdoor locations.
- This product is for ceiling mount applications only.
- This product can mount to either a 4" square electrical box
with round plaster ring or an octagon electrical box.
- This product can be dimmed with a standard incandescent
dimmer.
- This instruction shows a typical installation for indoor and
outdoor.
IMPORTANT INFORMATION
IMPORTANT SAFETY INSTRUCTIONS
To reduce the risk of fire, electrical shock, exposure to
excessive UV radiation, or injury to persons:
- Do not look directly at the lamp while the fixture is on.
- RISK OF FIRE: Use only the type of lamp and maximum
wattage indicated in this instruction manual.
- Never cover the halogen lamp with anything other than a
lamp shield provided by Edge Lighting and never place
flammable material close to the fixture.
- Never turn the fixture on and off by connecting and
disconnecting the halogen lamp.
- Do not touch the fixture head, shade or lamp shield while
the fixture is on. These surfaces may be VERY HOT.
- Do not touch lamp at anytime. Use a soft cloth instead as oil
from skin may damage lamp.
- It is normal for a new halogen lamp to produce minor
smoke when first turned on.
- Turn power off and allow to cool before replacing lamp.
© 2009 Edge Lighting. All Rights Reserved.