User guide

E
5: Carefully feed the fixture wires from the threaded side of the
stem into the stem and completely tighten the stem to the
hinge. Tighten the M3 screw on the hinge with 1.5 mm Allen
wrench.
6: Tighten the remaining stems to all other hinges.
5
STEM
FIXTURE BODY
POWER
WIRES
HINGE
1.5MM ALLEN
WRENCH
7: Feed the power wires coming out of the stem through the
square canopy. Slide the canopy bushing completely onto
the stem and secure it in place by tightening the M4 set
screw with the provided 2mm Allen wrench.
7
8: Connect the red fixture wire to the +24VDC power supply
wire with a wire nut.
9: Connect the black fixture wire to the -24VDC power supply
wire with a wire nut.
NOTE: It is recommended another person hold the fixture while
the electrician connects the power to the fixture.
WIRE NUT
12
10: Place all wires and wire nut connections into the junction box and simultaneously align and insert the stem(s) completely
into the base(s).
11: Align the 4" square canopy holes with the junction box holes and secure the canopy in place by tightening the two provided
#8-32 screws through the canopy holes into the junction box holes.
12: Secure the remaining stem(s) to the base(s) by tightening the M4 set screw on the base with the 2MM Allen wrench.
2MM ALLEN
WRENCH
M4 SET
SCREW
I
13: Rotate the fixture head to desired angle.
STEM
HINGE
13
FIXTURE
HEAD
F
G
H
11
2MM ALLEN
WRENCH
M4 SET
SCREW
NOTE: The 24 VDC power wires must be present to the
junction box. Refer to the installation instructions provided with
power supply.
8
9
#8-32 SCREW(2x)
6