User guide

FJP-26RE-LED-2-_
A
1: Loosen and remove the six Phillips screws from the canopy
to remove the mounting plate.
Installation Instructions for 26" Rectangle 2 Port Fast Jack LED Power
Canopy
Install the Canopy
1
904-FJP-26RE-LED-2-01
1718 W. Fullerton Ave
Chicago, IL 60614
Tel: [phone]
Fax: [phone]
www.edgelighting.com
[e-mail]
PHILLIPS SCREW
1
1
MOUNTING PLATE
CANOPY
© 2009 Edge Lighting. All Rights Reserved.
1
B
2 Align the mounting plate holes with the electrical box holes
and mark a point through the mounting plate holes onto the
ceiling. These points are used for the anchors.
:
MOUNTING PLATE
ELECTRICAL BOX HOLE
2 2
C
3
4
ANCHOR
3: Tap the anchors onto the marked points up to the threaded
portion with a hammer.
4: Screw in the threaded portion of the anchors with a Phillips
screwdriver.
D
#8-32 SCREW
CROSSBAR ASSEMBLY
5:
center hole.
6: Mount the crossbar assembly to the electrical box holes with
the provided #8-32 screws.
Feed the power wires through the crossbar assembly
5
6
6
SAVE THESE INSTRUCTIONS!
- This product is ETL listed for indoor dry locations.
- This product can be installed to a 4" electrical box with
round plaster ring, or to an octagon electrical box.
- For dimming information visit www.edgelighting.com.
- This product can be used with LED or halogen Fast Jack
fixtures.
IMPORTANT INFORMATION