Owner's manual

RIDGED WIRE

SMOOTH WIRE

CORD

ANCHOR

#8 SCREW

MOUNTING

BRACKET

5: Line up the mounting bracket holes with the anchors and

secure the fixture to the anchors with the two #8 screws

provided.

ARM

2MM ALLEN WRENCH

M4 SET

SCREW

6: To adjust the Cody height, loosen the two M4 set screws on

the mounting bracket with the provided 2mm Allen wrench.

Adjust the Cody by sliding it up or down. When the desired

height is achieved tighten the two M4 set screws with the

2mm Allen wrench.

MOUNTING

BRACKET

7: Select the location on the cord where the switch will be

installed.

8: With a sharp knife cut about 1" in the cord web. Make sure

not to nick the insulation on either wire.

9: Cut the smooth wire in half.

NUT

SMOOTH

WIRE

RIDGED

WIRE

10: Loosen the screw on one side of the switch to remove the

nut from the other side. Separate the two halves from each

other.

11: Place the half of the switch without the wheel onto the cut

portion of the cord. The uncut ridged wire should pass

through the half where the cut wire will be blocked in the

middle. This will ensure the switch connectivity.

12: Replace the half with wheel onto the other half so that the

sharp prongs pierce the insulation of the cut wire.

13: Replace the nut and tighten the screw ensuring that both

halves are mated properly.

CORD WEB

SHARP PRONG

WHEEL