Instruction Manual

ARM
2MM ALLEN WRENCH
M4 SET SCREW
11
11: To adjust the height, loosen the four M4 set screw on
the mounting brackets with the provided 2mm Allen
wrench. Adjust the Cody to the desired height by sliding it
up or down. Tighten the four M4 set screws with the 2mm
Allen wrench.
MOUNTING BRACKET
G
11
H
12
THUMB
NUT
CUTOUT
14
13
12: Connect each low voltage LED power supply wire (red
wire) to one fixture wire with a wire nut.
13: Place the excess wires and wire nuts inside the electrical
box.
14: Line up the canopy cut out edge with the fixture wires.
Place the canopy onto the electrical box and tighten the
thumb nut to the crossbar assembly nipple.
15: Hang the frame cable into the two mounting bracket slots.
12
I
MOUNTING BRACKET SLOT
FRAME CABLE
J
NOTE: The Cody 12" contains 12 watt integrated LED lamps.
These lamps are rated for 50,000 hours.
16: Rotate the fixture head to properly wash the picture with
light.
FIXTURE HEAD
PICTURE
16
3
15
15