Instruction Manual

ALPHA-16-F1-_
M2-IND-_
Installation Instructions for Alpha 16 and 24 (Fluorescent Version)
904-ALPHA-24-F1-01
SAVE THESE INSTRUCTIONS!
- This product is ETL listed for indoor dry locations.
- This product is wall mounted only.
- This product can mount to either a 4" square electrical box
with round plaster ring or an octagon electrical box.
IMPORTANT INFORMATION
1718 W. Fullerton Ave
Chicago, IL 60614
Tel: [phone]
Fax: [phone]
www.edgelighting.com
[e-mail]
© 2009 Edge Lighting. All Rights Reserved.
1
Install the Fixture
2:
the provided #8-32 screws so that the two inner threaded
holes (spaced 2-1/8" apart) on crossbar are leveled
horizontally.
Mount the universal crossbar to the electrical box holes with
#8-32 SCREW
UNIVERSAL CROSSBAR
ELECTRICAL
BOX HOLE
2
B
2
2
3: Feed the power wires through the canopy center hole.
4: Make sure that the canopy is grounded in accordance with
local electrical codes.
5: Secure the canopy to the universal crossbar by tightening
the two #8-32 screws through the mounting bracket holes
into the two inner threaded crossbar holes.
C
2-1/8"
APART
3
5
5
CANOPY
#8-32 SCREW
MOUNTING
BRACKET
POWER
WIRES
A
CANOPY
#8-32 SCREW
MOUNTING
BRACKET
UNIVERSAL
CROSSBAR
1:
the universal crossbar.
Loosen the two #8-32 screws from the canopy to remove
1
1
ALPHA-24-F1-_