Owner's manual

POWER
HOUSING
3
4
CAP
3/8-24 SET SCREW
2
C
11
3/32 ALLEN
WRENCH
11
#8-32
SCREW
10: Place all wires inside the electrical box.
11: Secure the power feed canopy to the electrical box by
tightening the two provided #8-32 screws with the 3/32
Allen wrench.
Install the Power Feed Canopy
Wires to Monorail
1/16 ALLEN
WRENCH
#6-32 SET SCREW
STRAIGHT ISOLATING
CONNECTOR
1
2
D
1: Push the straight isolating connectors completely into one
Monorail section end and push the other Monorail section
entirely onto the straight isolating connectors.
2: Tighten the #6-32 set screw on the isolating connectors
firmly with the 1/16 Allen wrench. Do not over tighten the
set screws as this may strip the threads.
E
3: Remove the caps from the power housings.
4: Slightly loosen the 3/8-24 set screw on the caps with the
3/16 Allen wrench provided, DO NOT REMOVE THEM.
5: Place each power housing onto one Monorail section. Make
sure that the straight isolating connectors are in the
middle between the power housings. Make sure that
the Monorail sections are supported by the standoffs. Refer
to the instructions provided with the standoffs.
6: Tighten the caps to the power housings. Make sure the
caps are not cross threaded.
7: Tighten the 3/8-24 set screw on the caps with the 3/16 Allen
wrench firmly for proper power connection.
F
MONORAIL
CAP
3/8-24
SET SCREW
POWER
HOUSING
5
STRAIGHT
ISOLATING
CONNECTORS
6
7
MONORAIL
G
8: If the power feed wires are sagging, loosen the four M4 set
screws on the plastic disk with the 2mm Allen wrench.
9: Push the power feed wires into the canopy and tighten the
four M4 set screws with the 2mm Allen wrench.
2MM ALLEN WRENCH
M4 SET SCREW
PLASTIC DISK
8
9
3/16 ALLEN WRENCH
3/16 ALLEN
WRENCH
7