User guide

Initial Configuration
4-6
4
- Default Gateway – Normally, for wireless clients and stations in the attached
LAN, the gateway address is the same as the LAN IP address. For a larger LAN
with stations located on other subnets, type the IP address of the default
gateway router in the text field provided.
• DHCP Service for LAN — Set the DHCP service configuration of the Mini AP
Router.
- DHCP Service – Enable the DHCP server.
- DHCP Start – Specify the start IP address of a range that the DHCP server can
allocate to DHCP clients. Note that the address pool range is always in the
same subnet as the unit’s IP setting.
- Max Client Q’ty – Specify the maximum number of IP addresses to allocate to
clients.
- DHCP Lease Time (Minutes) – Select a time limit for the use of an IP address
from the IP pool. When the time limit expires, the client has to request a new IP
address.
4. Wireless-VAP1 Configuration — Sets the wireless Service Set Identifier
(SSID) and wireless security encryption key for the VAP1 wireless network.
Figure 4-5. Setup Wizard - Wireless-VAP1 Settings (AP+WDS Parent Mode)
The displayed items on this page can be described as follows:
Wireless Configuration — Enables radio communications for the VAP interface.
(Default: Enabled)
• AP+WDS Parent – The VAP operates as an access point providing a WLAN for
wireless clients. An AP using WDS can function as a wireless network bridge to
allow a wireless connection between two wired network segments.