Users Manual

Quick Start Guide

– 2 –

Mount the MLTG-CN

a. Mount on a Pole

b. Mount on a Wall

c. Use Precision Brackets (Optional)

Connect Power

Verify Power is On

1. Feed the steel-band clamps through the pole-mount bracket

points on the back of the MLTG-CN and then lightly fasten them

around the pole.

2. Align the MLTG-CN antenna with a nearby Distribution Node

before tightening the clamps securely.

1. Drill two holes in the wall for the included expansion plugs. Insert

the expansion plugs and the two screws in the holes.

2. Align the MLTG-CN mounting bracket with the screws and then

slide the device down until it snaps into its secured position.

Two optional precision brackets (ordered separately) are designed for

wall and pole mounting and provide additional degrees of movement

for antenna alignment.

Connect the other end of the outdoor-rated Ethernet cable from the

Uplink (PoE) port to the 802.3at-compliant power injector.

Check the LEDs

The Uplink (PoE) LED should blink slowly during boot-up and be on or

blinking when operating normally.