Installation guide

Chapter 6

| Wireless Controller Management

How to Connect to the Console Port

– 37 –

The serial port’s configuration requirements are as follows:

◆ Default Baud rate—115,200 bps

◆ Character Size—8 Characters

◆ Parity—None

◆ Stop bit—One

◆ Data bits—8

◆ Flow control—none

Figure 17: Console Port Connection

Follow these steps to connect to the Console port:

1. Attach the DB-9 end of the included RJ-45-to-DB-9 serial cable to a DB-9 COM

port connector on a management PC.

2. Attach the RJ-45 end of the serial cable to the Console port on the wireless

controller.

3. Configure the PC’s COM port required settings using VT-100 terminal emulator

software (such as HyperTerminal) running on the management PC.

For a detailed description of connecting to the console and using the wireless

controller’s command line interface (CLI), refer to the CLI Reference Guide.

Console Cable