Installation guide

Chapter 6 | AP Management
How to Set an IP Address (ECWO5110-L)
– 44 –
How to Set an IP Address (ECWO5110-L)
The ECWO5110-L requires management from a EWS4502 wireless access controller
(AC), which can automatically discover the AP. If the network environment requires
that you first configure a static IP address for the AP and AC, make a connection to
the AP’s Console port and then follow these steps:
1. Make a connection to the AP Console port and log in to the CLI (see previous
section).
2. Press [Ctrl+c] to stop the DHCP process of the AP.
3. At the prompt, enter “cli” then press return to access the CLI prompt.
4. Use the following command to set the IP address.
configure interface ethernet ip address [IPv4] [netmask] [gateway]
Example:
configure interface ethernet ip address 10.7.9.25 255.255.255.0 10.7.9.254
5. Enter “exit” to leave the CLI prompt.
6. Set access controller IP addresses using the following commands:
set_sys_ac_ip_primary x.x.x.x
set_sys_ac_ip_secondary x.x.x.x
Example:
# set_sys_ac_ip_primary 10.7.9.251
# set_sys_ac_ip_secondary 10.7.9.252
7. Use the command “apconf_cmd Saveall” to save the AP settings:
8. Reboot the AP using the “reboot” command.
Note: To set the AP back to DHCP, follow the same procedure (without Step 6)
using the command “configure interface ethernet ip address [dhcp].”