Installation guide
Chapter 2
| Installation Overview
System Configuration
– 15 –
System Configuration
At each location where a unit is installed it must be connected to the local network,
either by using the power injector module, or by a direct connection to an
IEEE 802.3at-compliant LAN switch.
The following figure illustrates the system component connections.
Figure 5: System Configuration
AP Installation Tasks
Follow these tasks to install the AP in your network. For full details on each task, go
to the relevant chapter or section by clicking on the link.
Unpack package and check contents
Unpack your AP and check the package contents to be sure you have received all
the items.
Before installing your AP, be sure to review all the safety statements and guidelines
in the Regulatory and Safety Information document.
Mount the AP
After planning your installation, mount the unit on a pole, mast, or tower using the
mounting bracket. Also, install the external antennas required for your wireless
service. Be sure to use the antenna connector covers to seal any unused
connectors.
Indoor Outdoor
LAN Switch
AC Power
Power
Injector
AP Unit
Ground Wire
Ethernet Cable
Ethernet
Cable
External Antenna
Task 1
Task 2