Installation guide
Table Of Contents
- Chapter 1: Introduction
- Chapter 2: Initial Configuration
- Chapter 3: Configuring the Switch
- Using the Web Interface
- Navigating the Web Browser Interface
- Web Configuration
- Displaying Status Overview
- Showing Port Statistics
- Displaying the System Name
- Setting the Switch’s IP Address
- Configuring the Logon Password
- Tools
- Register Product
- Port Configuration
- Storm Control
- Port Mirroring
- Cable Diagnostic
- Trunk Membership
- Trunk Configuration
- LACP Setup
- LACP Status
- Configuring VLAN Groups
- 802.1X
- LLDP Settings
- LLDP Neighbor Table
- RSTP
- QoS Settings
- SNMP
- PoE
- Appendix A: Software Specifications
- Appendix B: Troubleshooting
Troubleshooting
B-2
3. In the list of components used by this connection on the General tab, select
Internet Protocol (TCP/IP), and then click the Properties button.
4. In the Internet Protocol (TCP/IP) Properties dialog box, click to select Use the
following IP address. Then type your intended IP address, Subnet mask, and
Default gateway in the provided text boxes
5. Click OK to save the changes.
To change the IP address of a Windows 2000 PC:
1. Click Start, Settings, then Network and Dial-up Connections.
2. For the IP address you want to change, right-click the network connection icon,
and then click Properties.
3. In the list of components used by this connection on General tab, select Internet
Protocol (TCP/IP), and then click the Properties button.
4. In the Internet Protocol (TCP/IP) Properties dialog box, click to select Use the
following IP address. Then type your intended IP address, Subnet mask, and
Default gateway in the provided text boxes.
5. Click OK to save the changes.
Note: For users of other operating systems, refer to your system documentation for
information on changing the PC’s IP address.