Installation guide
Table Of Contents
- Chapter 1: Introduction
- Chapter 2: Initial Configuration
- Chapter 3: Configuring the Switch
- Using the Web Interface
- Navigating the Web Browser Interface
- Web Configuration
- Displaying Status Overview
- Showing Port Statistics
- Displaying the System Name
- Setting the Switch’s IP Address
- Configuring the Logon Password
- Tools
- Register Product
- Port Configuration
- Storm Control
- Port Mirroring
- Cable Diagnostic
- Trunk Membership
- Trunk Configuration
- LACP Setup
- LACP Status
- Configuring VLAN Groups
- 802.1X
- LLDP Settings
- LLDP Neighbor Table
- RSTP
- QoS Settings
- SNMP
- PoE
- Appendix A: Software Specifications
- Appendix B: Troubleshooting
Configuring the Switch
3-44
Web – Click QOS, Settings. In QoS Mode, select Port-based, 802.1p, or DSCP to
configure the related parameters. When the QoS Mode is set to Port-based, the
following table is displayed.
Figure 3-30 Port-based QoS Settings
When the QoS Mode is set to 802.1p, the 802.p Configuration table is displayed as
shown below.
Figure 3-31 802.1p Configuration