Installation guide
Table Of Contents
- Chapter 1: Introduction
- Chapter 2: Initial Configuration
- Chapter 3: Configuring the Switch
- Using the Web Interface
- Navigating the Web Browser Interface
- Web Configuration
- Displaying Status Overview
- Showing Port Statistics
- Displaying the System Name
- Setting the Switch’s IP Address
- Configuring the Logon Password
- Tools
- Register Product
- Port Configuration
- Storm Control
- Port Mirroring
- Cable Diagnostic
- Trunk Membership
- Trunk Configuration
- LACP Setup
- LACP Status
- Configuring VLAN Groups
- 802.1X
- LLDP Settings
- LLDP Neighbor Table
- RSTP
- QoS Settings
- SNMP
- PoE
- Appendix A: Software Specifications
- Appendix B: Troubleshooting
Web Configuration
3-35
LLDP Neighbor Table
This page provides information on neighboring devices.
Field Attributes
• Local Port - The local port to which a remote LLDP-capable device is attached.
• Chassis ID - An identifier for the particular chassis in this system. In most cases,
this is the MAC address of the remote device.
• Remote Port ID - The port from which this LLDPDU was transmitted.
• System Name - The neighboring device’s full name. This string indicates the
system’s administratively assigned name.
• Port Description - The port description and information of the neighboring device.
• System Capabilities - The capabilities that define the primary function(s) of the
system. (A “+” symbol indicates that the displayed capabilities are enabled.)
• Management Address - The IPv4 address of the remote device. (If no
management address is available, the address should be the MAC address for the
CPU or for the port sending this advertisement.)
Web – Click LLDP, Neighbor.
Figure 3-27 LLDP Neighbor
RSTP
The Spanning Tree Algorithm (STA) can be used to detect and disable network
loops, and to provide backup links between switches, bridges or routers. This allows
the switch to interact with other bridging devices (that is, an STA-compliant switch,
bridge or router) in your network to ensure that only one route exists between any
two stations on the network, and provide backup links which automatically take over
when a primary link goes down.
STA uses a distributed algorithm to select a bridging device (STA-compliant switch,
bridge or router) that serves as the root of the spanning tree network. It selects a
root port on each bridging device (except for the root device) which incurs the lowest
path cost when forwarding a packet from that device to the root device. Then it
selects a designated bridging device from each LAN which incurs the lowest path
cost when forwarding a packet from that LAN to the root device. All ports connected
to designated bridging devices are assigned as designated ports. After determining