Installation guide
Table Of Contents
- Chapter 1: Introduction
- Chapter 2: Initial Configuration
- Chapter 3: Configuring the Switch
- Using the Web Interface
- Navigating the Web Browser Interface
- Web Configuration
- Displaying Status Overview
- Showing Port Statistics
- Displaying the System Name
- Setting the Switch’s IP Address
- Configuring the Logon Password
- Tools
- Register Product
- Port Configuration
- Storm Control
- Port Mirroring
- Cable Diagnostic
- Trunk Membership
- Trunk Configuration
- LACP Setup
- LACP Status
- Configuring VLAN Groups
- 802.1X
- LLDP Settings
- LLDP Neighbor Table
- RSTP
- QoS Settings
- SNMP
- PoE
- Appendix A: Software Specifications
- Appendix B: Troubleshooting
Web Configuration
3-31
• AuthTimeoutsWhileAuthenticating – The number of times that the state machine
transitions from AUTHENTICATING to ABORTING, as a result of the Backend
Authentication state machine indicating authentication timeout.
• AuthEapStartsWhileAuthenticating – the number of times that the state machine
transitions from AUTHENTICATING to ABORTING, as a result of an EAPOL-Start
message being received from the Supplicant.
• AuthReauthsWhileAuthenticated – The number of times that the state machine
transitions from AUTHENTICATING to ABORTING, as a result of a
reauthentication request.
• AuthEapLogoffWhileAuthenticated – The number of times that the state machine
transitions from AUTHENTICATING to ABORTING, as a result of an
EAPOL-Logoff message being received from the Supplicant.
• EapLogoffsWhileConnecting – The number of times that the state machine
transitions from CONNECTING to DISCONNECTED as a result of receiving an
EAPOL-Logoff message.
• AuthSuccessesWhileAuthenticating – the number of times that the state machine
transitions from AUTHENTICATING to AUTHENTICATED, as a result of the
Backend Authentication state machine indicating successful authentication of the
Supplicant.
• AuthFailWhileAuthenticating – The number of times that the state machine
transitions from AUTHENTICATING to HELD, as a result of the Backend
Authentication state machine indicating authentication failure.
• AuthEapLogoffWhileAuthenticating – The number of times that the state machine
transitions from AUTHENTICATING to ABORTING, as a result of an
EAPOL-Logoff message being received from the Supplicant.
• AuthEapStartsWhileAuthenticated – The number of times that the state machine
transitions from AUTHENTICATING to ABORTING, as a result of an EAPOL-Start
message being received from the Supplicant.
Backend Authenticator Counters
• backendResponses – The number of times that the state machine sends an initial
Access-Request packet to the Authentication server (i.e., executes
sendRespToServer on entry to the RESPONSE state). Indicates that the
Authenticator attempted communication with the Authentication Server.
• backendOtherRequestsToSupplicant – The number of times that the state
machine sends an EAP-Request packet (other than an Identity, Notification,
Failure or Success message) to the Supplicant (i.e., executes txReq on entry to the
REQUEST state). Indicates that the Authenticator chose an EAP-method.
• backendAuthFails – The number of times that the state machine receives an
EAP-Failure message from the Authentication Server. Indicates that the Supplicant
has not authenticated to the Authentication Server.
• backendAccessChallenges – The number of times that the state machine receives
an initial Access-Challenge packet from the Authentication server. Indicates that
the Authentication Server has communication with the Authenticator.