Installation guide
Table Of Contents
- Chapter 1: Introduction
- Chapter 2: Initial Configuration
- Chapter 3: Configuring the Switch
- Using the Web Interface
- Navigating the Web Browser Interface
- Web Configuration
- Displaying Status Overview
- Showing Port Statistics
- Displaying the System Name
- Setting the Switch’s IP Address
- Configuring the Logon Password
- Tools
- Register Product
- Port Configuration
- Storm Control
- Port Mirroring
- Cable Diagnostic
- Trunk Membership
- Trunk Configuration
- LACP Setup
- LACP Status
- Configuring VLAN Groups
- 802.1X
- LLDP Settings
- LLDP Neighbor Table
- RSTP
- QoS Settings
- SNMP
- PoE
- Appendix A: Software Specifications
- Appendix B: Troubleshooting
Web Configuration
3-23
LACP Status
This page allows you display the operational state for the local and remote side of an
link aggregation.
Field Attributes
Aggregation Information
• Aggregation Group - Identifier for a local link aggregation group.
• Partner MAC Address - Physical address of device at other end of link.
• Local Ports Aggregated - Local ports participating in this LAG.
• Seconds Since Last Change - Time since the last LACP packet was received.
LACP Port Status
• Port - The port number.
• Port Active - Shows if the port is a member of an active LACP group.
• Partner Port Number - A list of the ports attached at the remote end of this LAG
link member.
• Operational Port Key - Current operational value of the key used by this LAG.
Web – Click TRUNKS, LACP Status.
Figure 3-20 LACP Status Overview