Installation guide
Table Of Contents
- Chapter 1: Introduction
- Chapter 2: Initial Configuration
- Chapter 3: Configuring the Switch
- Using the Web Interface
- Navigating the Web Browser Interface
- Web Configuration
- Displaying Status Overview
- Showing Port Statistics
- Displaying the System Name
- Setting the Switch’s IP Address
- Configuring the Logon Password
- Tools
- Register Product
- Port Configuration
- Storm Control
- Port Mirroring
- Cable Diagnostic
- Trunk Membership
- Trunk Configuration
- LACP Setup
- LACP Status
- Configuring VLAN Groups
- 802.1X
- LLDP Settings
- LLDP Neighbor Table
- RSTP
- QoS Settings
- SNMP
- PoE
- Appendix A: Software Specifications
- Appendix B: Troubleshooting
Web Configuration
3-19
Cable Diagnostic
You can perform cable diagnostics for all ports or selected ports to diagnose any
cable faults (short, open etc.) and feedback a distance to the fault.
Field Attributes
• Cable Diagnostics – Cable diagnostics is performed on a per-port basis. Select
the port number from the drop-down list.
• Cable Status – Shows the cable length, operating conditions and isolates a
variety of common faults that can occur on Category 5 twisted pair cabling.
Web – Click PORTS, Cable Diagnostics.
Figure 3-16 Cable Diagnostics