Installation guide
Table Of Contents
- Chapter 1: Introduction
- Chapter 2: Initial Configuration
- Chapter 3: Configuring the Switch
- Using the Web Interface
- Navigating the Web Browser Interface
- Web Configuration
- Displaying Status Overview
- Showing Port Statistics
- Displaying the System Name
- Setting the Switch’s IP Address
- Configuring the Logon Password
- Tools
- Register Product
- Port Configuration
- Storm Control
- Port Mirroring
- Cable Diagnostic
- Trunk Membership
- Trunk Configuration
- LACP Setup
- LACP Status
- Configuring VLAN Groups
- 802.1X
- LLDP Settings
- LLDP Neighbor Table
- RSTP
- QoS Settings
- SNMP
- PoE
- Appendix A: Software Specifications
- Appendix B: Troubleshooting
Configuring the Switch
3-12
Configuring the Logon Password
The administrator has write access for all parameters governing the onboard agent.
You should therefore assign a new administrator password as soon as possible, and
store it in a safe place.
Field Attributes
Password – Specifies the user password.
(Range: 1-16 characters plain text, case sensitive)
Note:
If you cannot remember the password, you can restore the original settings by
following the procedure described in “Forgot or Lost Password” on page B-1.
Web – Click System, Password. To change the password for the administrator, enter
current password, the new password, confirm it by entering it again, then click
APPLY.
Figure 3-7 Password Settings