Installation guide
Table Of Contents
- Chapter 1: Introduction
- Chapter 2: Initial Configuration
- Chapter 3: Configuring the Switch
- Using the Web Interface
- Navigating the Web Browser Interface
- Web Configuration
- Displaying Status Overview
- Showing Port Statistics
- Displaying the System Name
- Setting the Switch’s IP Address
- Configuring the Logon Password
- Tools
- Register Product
- Port Configuration
- Storm Control
- Port Mirroring
- Cable Diagnostic
- Trunk Membership
- Trunk Configuration
- LACP Setup
- LACP Status
- Configuring VLAN Groups
- 802.1X
- LLDP Settings
- LLDP Neighbor Table
- RSTP
- QoS Settings
- SNMP
- PoE
- Appendix A: Software Specifications
- Appendix B: Troubleshooting
Web Configuration
3-11
Note: If you cannot remember the switch’s IP address, you can restore the original
settings by following the procedure described in the “Troubleshooting” section.
Manual Configuration
Web – Click SYSTEM, LAN Settings. Enter the IP address, subnet mask and
gateway, then click APPLY. Note that if you change the switch IP address, you must
close the web interface and start a new session using the new IP address.
Figure 3-6 LAN Settings