Installation guide
Table Of Contents
- Chapter 1: Introduction
- Chapter 2: Initial Configuration
- Chapter 3: Configuring the Switch
- Using the Web Interface
- Navigating the Web Browser Interface
- Web Configuration
- Displaying Status Overview
- Showing Port Statistics
- Displaying the System Name
- Setting the Switch’s IP Address
- Configuring the Logon Password
- Tools
- Register Product
- Port Configuration
- Storm Control
- Port Mirroring
- Cable Diagnostic
- Trunk Membership
- Trunk Configuration
- LACP Setup
- LACP Status
- Configuring VLAN Groups
- 802.1X
- LLDP Settings
- LLDP Neighbor Table
- RSTP
- QoS Settings
- SNMP
- PoE
- Appendix A: Software Specifications
- Appendix B: Troubleshooting
Navigating the Web Browser Interface
3-3
Configuration Options
Configurable parameters have a dialog box or a drop-down list. Once a configuration
change has been made on a page, be sure to click on the Apply button to confirm
the new setting. The following table summarizes the web page configuration
buttons.
Note:
To ensure proper screen refresh, be sure that Internet Explorer is configured as
follows: Under the menu “Tools / Internet Options / General / Temporary Internet
Files / Settings,” the setting for item “Check for newer versions of stored pages”
should be “Every visit to the page.”
Panel Display
The web agent displays an image of the switch’s ports. The port will turn green when
the corresponding front-panel port is in connection with another device. To show the
port number, place mouse pointer onto the intended port.
Figure 3-2 Front Panel Indicators
Table 3-1 Web Page Configuration Buttons
Button Action
Apply Sets specified values to the system.
Cancel Discards all changes and restores current values.
Help Links directly to web help.