Installation guide
Table Of Contents
- Chapter 1: Introduction
- Chapter 2: Initial Configuration
- Chapter 3: Configuring the Switch
- Using the Web Interface
- Navigating the Web Browser Interface
- Web Configuration
- Displaying Status Overview
- Showing Port Statistics
- Displaying the System Name
- Setting the Switch’s IP Address
- Configuring the Logon Password
- Tools
- Register Product
- Port Configuration
- Storm Control
- Port Mirroring
- Cable Diagnostic
- Trunk Membership
- Trunk Configuration
- LACP Setup
- LACP Status
- Configuring VLAN Groups
- 802.1X
- LLDP Settings
- LLDP Neighbor Table
- RSTP
- QoS Settings
- SNMP
- PoE
- Appendix A: Software Specifications
- Appendix B: Troubleshooting
vii
Figures
Figure 3-1 Home Page 3-2
Figure 3-2 Front Panel Indicators 3-3
Figure 3-3 System Information 3-8
Figure 3-4 Port Statistics 3-9
Figure 3-5 System Name 3-10
Figure 3-6 LAN Settings 3-11
Figure 3-7 Password Settings 3-12
Figure 3-8 Reset to Factory Defaults 3-13
Figure 3-9 Upgrade Firmware 3-13
Figure 3-10 Upload/Download Configuration 3-14
Figure 3-11 Restart Switch 3-14
Figure 3-12 Register Product 3-15
Figure 3-13 Port Configuration 3-16
Figure 3-14 Port Broadcast Control 3-17
Figure 3-15 Port Mirroring 3-18
Figure 3-16 Cable Diagnostics 3-19
Figure 3-17 Trunk Membership 3-20
Figure 3-18 Trunk Configuration 3-21
Figure 3-19 LACP Port Configuration 3-22
Figure 3-20 LACP Status Overview 3-23
Figure 3-21 VLAN Settings 3-25
Figure 3-22 VLAN Group Settings 3-26
Figure 3-23 VLAN Settings 3-27
Figure 3-24 802.1X Configuration 3-30
Figure 3-25 802.1X Statistics 3-33
Figure 3-26 LLDP Configuration 3-34
Figure 3-27 LLDP Neighbor 3-35
Figure 3-28 RSTP Configuration 3-39
Figure 3-29 RSTP Configuration 3-41
Figure 3-30 Port-based QoS Settings 3-44
Figure 3-31 802.1p Configuration 3-44
Figure 3-32 DSCP Configuration 3-45
Figure 3-33 SNMP Configuration 3-46
Figure 3-34 POE Configuration 3-48