Installation guide

Spanning Tree Commands
4-225
4
Default Setting
3
Command Mode
Global Configuration
Command Usage
This command limits the maximum transmission rate for BPDUs.
Example
spanning-tree mst configuration
This command changes to Multiple Spanning Tree (MST) configuration mode.
Default Setting
• No VLANs are mapped to any MST instance.
• The region name is set the switch’s MAC address.
Command Mode
Global Configuration
Example
Related Commands
mst vlan (4-225)
mst priority (4-226)
name (4-227)
revision (4-227)
max-hops (4-228)
mst vlan
This command adds VLANs to a spanning tree instance. Use the no form to remove
the specified VLANs. Using the no form without any VLAN parameters to remove all
VLANs.
Syntax
[no] mst instance_id vlan vlan-range
• instance_id - Instance identifier of the spanning tree. (Range: 0-4094)
• vlan-range - Range of VLANs. (Range: 1-4094)
Default Setting
none
Console(config)#spanning-tree transmission-limit 4
Console(config)#
Console(config)#spanning-tree mst configuration
Console(config-mstp)#