Installation guide

General Security Measures
4-155
4
Example
web-auth
This command enables web authentication for a port. Use the no form to restore the
default.
Syntax
[no] web-auth
Default Setting
Disabled
Command Mode
Interface Configuration
Command Usage
Both web-auth system-auth-control for the switch and web-auth for a port
must be enabled for the web authentication feature to be active.
Example
web-auth re-authenticate (Port)
This command ends all web authentication sessions connected to the port and
forces the users to re-authenticate.
Syntax
web-auth re-authenticate interface interface
• interface - Specifies a port interface.
• ethernet unit/port1
- unit - This is unit 1.
- port - Port number. (Range: 1-28)
Default Setting
None
Command Mode
Privileged Exec
Example
Console(config)#web-auth system-auth-control
Console(config)#
Console(config-if)#web-auth
Console(config-if)#
Console#web-auth re-authenticate interface ethernet 1/2
Failed to reauth .
Console#