Installation guide

Command Line Interface
4-10
4
The access mode shown in the following tables is indicated by these abbreviations:
ACL (Access Control List Configuration) MST (Multiple Spanning Tree)
CM (Class Map Configuration) NE (Normal Exec)
GC (Global Configuration) PE (Privileged Exec)
IC (Interface Configuration) PM (Policy Map Configuration)
LC (Line Configuration) VC (VLAN Database Configuration)
SG (Server Group)
General Commands
Multicast Filtering Configures IGMP multicast filtering, query parameters, specifies ports
attached to a multicast router, and enables multicast VLAN registration
4-315
IP Interface Configures IP address for the switch 4-338
Table 4-5 General Commands
Command Function Mode Page
enable Activates privileged mode NE 4-11
disable Returns to normal mode from privileged mode PE 4-11
configure Activates global configuration mode PE 4-12
show history Shows the command history buffer NE, PE 4-12
reload Restarts the system PE 4-13
show reload Displays the time remaining until a delayed reset will take place PE 4-14
prompt Customizes the prompt used in PE and NE mode GC 4-14
end Returns to Privileged Exec mode any
config.
mode
4-15
exit Returns to the previous configuration mode, or exits the CLI any 4-15
quit Exits a CLI session NE, PE 4-16
help Shows how to use help any NA
? Shows options for command completion (context sensitive) any NA
Table 4-4 Command Groups (Continued)
Command Group Description Page