Installation guide

Command Groups
4-9
4
Command Groups
The system commands can be broken down into the functional groups shown below.
Table 4-4 Command Groups
Command Group Description Page
General Basic commands for entering privileged access mode, restarting the
system, or quitting the CLI
4-10
System Management Display and setting of system information, basic modes of operation,
maximum frame size, file management, console port and telnet
settings, system logs, SMTP alerts, system clock, switch clustering,
and UPnP
4-16
Simple Network
Management Protocol
Activates authentication failure traps; configures community access
strings, and trap managers; also configures IP address filtering
4-81
Authentication Configures user names and passwords, logon access using local or
remote authentication (including AAA), management access through
the web server, Telnet server and Secure Shell; as well as port security,
IEEE 802.1X port access control, and restricted access based on
specified IP addresses
4-95
General Security
Measures
Segregates traffic for clients attached to common data ports; and
prevents unauthorized access by configuring valid static or dynamic
addresses, web authentication, MAC address authentication, and
filtering DHCP requests and replies
4-142
Access Control List Provides filtering for IP frames (based on address, protocol, or TCP/
UDP port number or TCP control code) or non-IP frames (based on
MAC address or Ethernet type)
4-170
Interface Configures the connection parameters for all Ethernet ports,
aggregated links, and VLANs
4-182
Link Aggregation Statically groups multiple ports into a single logical trunk; configures
Link Aggregation Control Protocol for port trunks
4-196
Power over Ethernet Configures power output for connected devices 4-205
Mirror Port Mirrors data to another port for analysis without affecting the data
passing through or the performance of the monitored port
4-211
Rate Limiting Controls the maximum rate for traffic transmitted or received on a port 4-213
Address Table Configures the address table for filtering specified addresses, displays
current entries, clears the table, or sets the aging time
4-214
Spanning Tree Configures Spanning Tree settings for the switch 4-218
VLANs Configures VLAN settings, and defines port membership for VLAN
groups; also enables or configures private VLANs, protocol VLANs,
and voice VLANs
4-240
Link Layer Discovery
Protocol
Configures LLDP settings to enable information discovery about
neighbor devices
4-218
Class of Service Sets port priority for untagged frames, selects strict priority or weighted
round robin, relative weight for each priority queue, also sets priority for
TCP/UDP traffic types, and DSCP
4-277
Quality of Service Configures Differentiated Services 4-306