Installation guide

Class of Service Configuration
3-231
3
Web – Click Priority, Traffic Classes. The current mapping of CoS values to output
queues is displayed. Assign priorities to the traffic classes (i.e., output queues), then
click Apply.
Figure 3-131 Traffic Classes
CLI – The following example shows how to change the CoS assignments.
* Mapping specific values for CoS priorities is implemented as an interface configuration
command, but any changes will apply to the all interfaces on the switch.
Console(config)#interface ethernet 1/1 4-182
Console(config-if)#queue cos-map 0 0 4-301
Console(config-if)#queue cos-map 1 1
Console(config-if)#queue cos-map 2 2
Console(config-if)#end
Console#show queue cos-map ethernet 1/1 4-303
Information of Eth 1/1
CoS Value: 0 1 2 3 4 5 6 7
Priority Queue: 0 1 2 1 2 2 3 3
Console#