Installation guide

Address Table Settings
3-161
3
CLI – This example also displays the address table entries for port 1.
Changing the Aging Time
You can set the aging time for entries in the dynamic address table.
Command Attributes
• Aging Status – Enables/disables the function. (Default: Enabled)
• Aging Time – The time after which a learned entry is discarded.
(Range: 10-630 seconds; Default: 300 seconds)
Web – Click Address Table, Address Aging. Specify the new aging time, click Apply.
Figure 3-96 Setting the Address Aging Time
CLI – This example sets the aging time to 300 seconds.
Console#show mac-address-table interface ethernet 1/1 4-216
Interface Mac Address Vlan Type
--------- ----------------- ---- -----------------
Eth 1/ 1 00-12-CF-48-82-93 1 Delete-on-reset
Eth 1/ 1 00-12-CF-94-34-DE 2 Learned
Console#
Console(config)#mac-address-table aging-time 300 4-217
Console(config)#