Installation guide

User Authentication
3-57
3
CLI – Use the snmp-server view command to configure a new view. This example
view includes the MIB-2 interfaces table, and the wildcard mask selects all index
entries.
User Authentication
You can configure this switch to authenticate users logging into the system for
management access using local or remote authentication methods. Port-based
authentication using IEEE 802.1X can also be configured to control either
management access to the uplink ports or client access to the data ports. This
switch provides secure network management access
4
using the following options:
• User Accounts – Manually configure access rights on the switch for specified users.
• Authentication Settings – Use remote authentication to configure access rights.
• AAA – Provides a framework for configuring access control on the switch.
• HTTPS Settings – Provide a secure web connection.
• SSH Settings – Provide a secure shell (for secure Telnet access).
• Port Security – Configure secure addresses for individual ports.
• 802.1X – Use IEEE 802.1X port authentication to control access to specific ports.
• IP Filter – Filters management access to the web, SNMP or Telnet interface.
Console(config)#snmp-server view ifEntry.a
1.3.6.1.2.1.2.2.1.1.* included 4-89
Console(config)#exit
Console#show snmp view 4-90
View Name: ifEntry.a
Subtree OID: 1.3.6.1.2.1.2.2.1.1.*
View Type: included
Storage Type: nonvolatile
Row Status: active
View Name: readaccess
Subtree OID: 1.3.6.1.2
View Type: included
Storage Type: nonvolatile
Row Status: active
View Name: defaultview
Subtree OID: 1
View Type: included
Storage Type: nonvolatile
Row Status: active
Console#
4. For other methods of controlling client access, see “General Security Measures” on page
3-97.