Installation guide

Contents
x
Configuring Parameters for LACP Group Members 3-137
Configuring Parameters for LACP Groups 3-140
Displaying LACP Port Counters 3-141
Displaying LACP Settings and Status for the Local Side 3-142
Displaying LACP Settings and Status for the Remote Side 3-144
Setting Broadcast Storm Thresholds 3-146
Configuring Port Mirroring 3-148
Configuring Rate Limits 3-149
Rate Limit Configuration 3-149
Showing Port Statistics 3-150
Power Over Ethernet Settings 3-154
Switch Power Status 3-155
Setting a Switch Power Budget 3-156
Displaying Port Power Status 3-156
Configuring Port PoE Power 3-157
Address Table Settings 3-159
Setting Static Addresses 3-159
Displaying the Address Table 3-160
Changing the Aging Time 3-161
Spanning Tree Algorithm Configuration 3-162
Configuring Port and Trunk Loopback Detection 3-164
Displaying Global Settings 3-165
Configuring Global Settings 3-168
Displaying Interface Settings 3-172
Configuring Interface Settings 3-175
Configuring Multiple Spanning Trees 3-178
Displaying Interface Settings for MSTP 3-181
Configuring Interface Settings for MSTP 3-183
VLAN Configuration 3-184
IEEE 802.1Q VLANs 3-184
Enabling or Disabling GVRP (Global Setting) 3-187
Displaying Basic VLAN Information 3-188
Displaying Current VLANs 3-189
Creating VLANs 3-190
Adding Static Members to VLANs (VLAN Index) 3-192
Adding Static Members to VLANs (Port Index) 3-194
Configuring VLAN Behavior for Interfaces 3-195
Configuring IEEE 802.1Q Tunneling 3-197
Enabling QinQ Tunneling on the Switch 3-201
Adding an Interface to a QinQ Tunnel 3-202
Traffic Segmentation 3-203
Configuring Global Settings for Traffic Segmentation 3-204
Configuring Traffic Segmentation Sessions 3-204
Private VLANs 3-206
Displaying Current Private VLANs 3-206