System information

Simple Network Management Protocol
3-41
3
linkUp 1.3.6.1.6.3.1.1.5.4 A linkUp trap signifies that the SNMP entity,
acting in an agent role, has detected that the
ifOperStatus object for one of its
communication links left the down state and
transitioned into some other state (but not into
the notPresent state). This other state is
indicated by the included value of ifOperStatus.
authenticationFailure 1.3.6.1.6.3.1.1.5.5 An authenticationFailure trap signifies that the
SNMPv2 entity, acting in an agent role, has
received a protocol message that is not
properly authenticated. While all
implementations of the SNMPv2 must be
capable of generating this trap, the
snmpEnableAuthenTraps object indicates
whether this trap will be generated.
RMON Events (V2)
risingAlarm 1.3.6.1.2.1.16.0.1 The SNMP trap that is generated when an
alarm entry crosses its rising threshold and
generates an event that is configured for
sending SNMP traps.
fallingAlarm 1.3.6.1.2.1.16.0.2 The SNMP trap that is generated when an
alarm entry crosses its falling threshold and
generates an event that is configured for
sending SNMP traps.
Private Traps
swPowerStatus
ChangeTrap
1.3.6.1.4.1.259.6.10.94.2.1.0.1 This trap is sent when the power state changes.
swIpFilterRejectTrap 1.3.6.1.4.1.259.6.10.94.2.1.0.40 This trap is sent when an incorrect IP address is
rejected by the IP Filter.
pethPsePortOnOff
Notification
1.3.6.1.4.1.259.6.10.94.2.1.0.43 This notification indicates if a PSE (Power
Sourcing Equipment) Port is delivering power to
the PD (Powered Device). This notification is
sent on every status change except in search
mode.
pethPsePortPower
MaintenanceStatus
Notification
1.3.6.1.4.1.259.6.10.94.2.1.0.44 This notification indicates a Port Change Status
and is sent on every status change.
pethMainPower
UsageOnNotification
1.3.6.1.4.1.259.6.10.94.2.1.0.45 This notification indicates PSE Threshold
usage indication is on; the power usage is
above the threshold.
pethMainPower
UsageOffNotification
1.3.6.1.4.1.259.6.10.94.2.1.0.46 This notification indicates that the PSE
Threshold usage indication is off; the usage
power is below the threshold.
a. These are legacy notifications and therefore must be enabled in conjunction with the corresponding traps
on the SNMP Configuration menu.
Table 3-4 Supported Notification Messages (Continued)
Object Label Object ID Description