System information

Command Line Interface
4-230
4
show ip dhcp snooping binding
This command shows the DHCP snooping binding table entries.
Command Mode
Privileged Exec
Example
Switch Cluster Commands
Switch Clustering is a method of grouping switches together to enable centralized
management through a single unit. A switch cluster has a “Commander” unit that is
used to manage all other “Member” switches in the cluster. The management station
uses Telnet to communicate directly with the Commander throught its IP address,
and the Commander manages Member switches using cluster “internal” IP
addresses. There can be up to 36 Member switches in one cluster. Cluster switches
are limited to within a single IP subnet.
Console#show ip dhcp snooping binding
MacAddress IpAddress Lease(sec) Type VLAN Interface
----------------- --------------- ---------- -------------------- ---- ---------
11-22-33-44-55-66 192.168.0.99 0 Static 1 Eth 1/5
Console#
Table 4-77 Switch Cluster Commands
Command Function Mode Page
cluster Configures clustering on the switch GC
4-23
1
cluster commander Configures the switch as a cluster Commander GC 4-23
1
cluster ip-pool Sets the cluster IP address pool for Members GC 4-23
2
cluster member Sets Candidate switches as cluster members GC 4-23
2
rcommand Provides configuration access to Member switches GC 4-233
show cluster Displays the switch clustering status PE 4-234
show cluster members Displays current cluster Members PE
4-23
4
show cluster candidates Displays current cluster Candidates in the network PE 4-23
4