System information

Command Line Interface
4-160
4
- unit - Stack unit. (Range: 1)
- port - Port number. (Range: 1-26)
• port-channel channel-id (Range: 1-12)
Default Setting
Shows all interfaces.
Command Mode
Normal Exec, Privileged Exec
Command Usage
If no interface is specified, information on all interfaces is displayed.
Example
This example shows the configuration setting for port 2.
Console#show interfaces switchport ethernet 1/2
Broadcast Threshold: Enabled, scale:1000K level:5 octets/second
LACP Status: Disabled
Ingress Rate Limit: Disabled, scale:10M level:1
Egress Rate Limit: Disabled, scale:10M level:1
VLAN Membership Mode: Hybrid
Ingress Rule: Enabled
Acceptable Frame Type: All frames
Native VLAN: 1
Priority for Untagged Traffic: 0
GVRP Status: Disabled
Allowed VLAN: 1(u),4093(t),
Forbidden VLAN:
Private-VLAN Mode: NONE
Private-VLAN host-association: NONE
Private-VLAN Mapping: NONE
802.1Q-tunnel Status: Disable
802.1Q-tunnel Mode: NORMAL
802.1Q-tunnel TPID: 8100(Hex)
Console#
Table 4-47 Interfaces Switchport Statistics
Field Description
Broadcast threshold Shows if broadcast storm suppression is enabled or disabled; if enabled it also
shows the threshold level (page 4-156).
Lacp status Shows if Link Aggregation Control Protocol has been enabled or disabled
(page 4-167).
Ingress rate limit Shows if ingress rate limiting is enabled, and the current rate limit. (page 4-164).
Egress rate limit Shows if egress rate limiting is enabled, and the current rate limit. (page 4-164).
VLAN membership mode Indicates membership mode as Trunk or Hybrid (page 4-226).
Ingress rule Shows if ingress filtering is enabled or disabled (page 4-227).
Note: Ingress filtering is always enabled.
Acceptable frame type Shows if acceptable VLAN frames include all types or tagged frames only
(page 4-227).