System information

Port Configuration

3-115

Web – Click Port, Port/Trunk Broadcast Control. Set the threshold, mark the

Enabled field for the desired interface and click Apply.

Figure 3-75 Port Broadcast Control

CLI – Set the threshold, then enable broadcast control on any interface. The

following sets broadcast control threshold at 500 kbytes per second, and then

enables broadcast storm control for port 1.

Console(config)#broadcast byte-rate 100 level 5 4-156

Console(config)#interface ethernet 1/1 4-150

Console(config-if)#switchport broadcast 4-156

Console(config-if)#end

Console#show interfaces switchport ethernet 1/1 4-159

Information of Eth 1/1

Broadcast Threshold: Enabled, scale:100K level:5 octets/second

LACP Status: Disabled

Ingress Rate Limit: Disabled, scale:10M level:1

Egress Rate Limit: Disabled, scale:10M level:1

VLAN Membership Mode: Hybrid

Ingress Rule: Enabled

Acceptable Frame Type: All frames

Native VLAN: 1

Priority for Untagged Traffic: 0

GVRP Status: Disabled

Allowed VLAN: 1(u),4093(t),

Forbidden VLAN:

Private-VLAN Mode: NONE

Private-VLAN host-association: NONE

Private-VLAN Mapping: NONE

802.1Q-tunnel Status: Disable

802.1Q-tunnel Mode: NORMAL

802.1Q-tunnel TPID: 8100(Hex)

Console#