Instruction manual

C HAPTER 3 | Installing the Switch
Connecting to a Power Source
– 44 –
CONNECTING TO A POWER SOURCE
To connect a switch to a power source:
1. Insert the power cable plug directly into the AC socket located at the back of
the switch.
Figure 13: Power Socket
2. Plug the other end of the cable into a grounded, 3-pin, AC power source.
N OTE : SFP transceivers are hot-swappable. The switch does not need to
be powered off before installing or removing a transceiver. However,
always first disconnect the network cable before removing a
transceiver.
N OTE : SFP transceivers are not provided in the switch package.
MASTER CONTRACT: 176914 (LR 99150)
REPORT: 2296506
PROJECT: 2296506
_______________________________________________________________________________________
Instruction Manual 1 ( 15 of 16)