Installation guide

– 77 –
C SPECIFICATIONS
PHYSICAL CHARACTERISTICS
PORTS
ECS4610-26T: 20 10/100/1000BASE-T, with auto-negotiation
4 10/100/1000BASE-T shared with 4 SFP transceiver slots
2 10GBASE extender module slots for XFP transceivers
Two slots for stacking transceivers
ECS4610-50T:44 10/100/1000BASE-T, with auto-negotiation
4 10/100/1000BASE-T shared with 4 SFP transceiver slots
2 10GBASE extender module slots for XFP transceivers
Two slots for stacking transceivers
NETWORK INTERFACE
Ports 1-24/48: RJ-45 connector, auto MDI/MDI-X
10BASE-T: RJ-45 (100-ohm, UTP cable; Category 3 or better)
100BASE-TX: RJ-45 (100-ohm, UTP cable; Category 5 or better)
1000BASE-T: RJ-45 (100-ohm, UTP or STP cable; Category 5, 5e or 6)
*Maximum Cable Length - 100 m (328 ft)
Ports 25-28: RJ-45/SFP shared ports
1000BASE-T: RJ-45 (100-ohm, UTP or STP cable; Category 5, 5e or 6)
*Maximum Cable Length - 100 m (328 ft)
Gigabit fiber transmission: SFP transceiver slots
*The maximum length for fiber optic cable operating at Gigabit speed will
depend on the fiber type as listed under “1000 Mbps Gigabit Ethernet
Collision Domain” on page 64.
BUFFER ARCHITECTURE
ECS4610-26T: 2 Mbytes
ECS4610-50T: 2 Mbytes