Installation guide

– 53 –
A TROUBLESHOOTING
DIAGNOSING SWITCH INDICATORS
Table 11: Troubleshooting Chart
Symptom Action
Power LED is Off
◆ Check connections between the switch, the power cord and
the wall outlet.
◆ Contact your dealer for assistance.
DIAG LED On Amber
◆ Power cycle the switch to try and clear the condition.
◆ If the condition does not clear, contact your dealer for
assistance.
Port LED is Off
◆ Verify that the switch and attached device are powered on.
◆ Be sure the cable is plugged into both the switch and
corresponding device.
◆ If the switch is installed in a rack, check the connections to
the punch-down block and patch panel.
◆ Verify that the proper cable type is used and its length does
not exceed specified limits.
◆ Check the adapter on the attached device and cable
connections for possible defects. Replace the defective
adapter or cable if necessary.