User guide

C HAPTER 28 | Link Layer Discovery Commands
– 225 –
objects, and to increase the probability that multiple, rather than single
changes, are reported in each transmission.
◆ This attribute must comply with the rule: (4 * Delay Interval) ≤
Transmission Interval
EXAMPLE
AP(config)# lldp transmit delay-to-local-change 10
txDelay range is 1 to quter of msgTxInterval
AP(config)#
show lldp This command displays the current LLDP configuration.
COMMAND MODE
Exec
EXAMPLE
AP# show lldp
LLDP Information
===================================================================
Status :Enabled
Message Transmission Hold Time :5
Message Transmission Interval (seconds) :30
Reinitial Delay Time (seconds) :2
Transmission Delay Value (seconds) :2
===================================================================
AP#