User guide

– 146 –
17 SNMP COMMANDS
Controls access to this access point from management stations using the
Simple Network Management Protocol (SNMP), as well as the hosts that
will receive trap messages.
Table 14: SNMP Commands
Command Function Mode Page
snmp-server community Sets up the community access string to permit
access to SNMP commands
GC 147
snmp-server contact Sets the system contact string GC 147
snmp-server location Sets the system location string GC 148
snmp-server enable
server
Enables SNMP service and traps GC 148
snmp-server host Specifies the recipient of an SNMP notification
operation
GC 149
snmp-server trap Enables specific SNMP notifications GC 150
snmp-server vacm view Configures the VACM view GC 151
snmp-server vacm group Configures the VACM group GC 152
snmp-server user Sets the name of the SNMP v3 user GC 153
snmp-server target Configures SNMP v3 notification targets GC 154
snmp-server filter Configures SNMP v3 notification filters GC 155
show snmp vacm group Displays the VACM group Exec 158
show snmp vacm view Displays VACM views Exec 158
show snmp users Displays SNMP v3 user settings Exec 156
show snmp target Displays the SNMP v3 notification targets Exec 156
show snmp filter Displays the SNMP v3 notification filters Exec 157
show snmp Displays the status of SNMP communications Exec 157