User guide

C HAPTER 15 | System Clock Commands
– 142 –
EXAMPLE
This sets daylight savings time to be used from the Sunday in the fourth
week of April, to the Sunday in the fourth week of October.
AP(config)# sntp-server daylight-saving date-week 4 4 0 10 4 0
AP(config)#
sntp-server
timezone
This command sets the time zone for the access point’s internal clock.
SYNTAX
sntp-server timezone <hours>
hours - Number of hours before/after UTC.
(Range: -12 to +12 hours)
DEFAULT SETTING
+08 hours (Hong Kong, Perth, Singapore, Taipei)
COMMAND MODE
Global Configuration
COMMAND USAGE
This command sets the local time zone relative to the Coordinated
Universal Time (UTC, formerly Greenwich Mean Time or GMT), based on
the earth’s prime meridian, zero degrees longitude. To display a time
corresponding to your local time, you must indicate the number of hours
and minutes your time zone is east (before) or west (after) of UTC.
EXAMPLE
AP(config)#sntp-server timezone +8
AP(config)#
show sntp This command displays the current time and configuration settings for the
SNTP client.
COMMAND MODE
Exec
EXAMPLE
AP#show sntp
SNTP Information
===========================================================
Service State : ENABLED
SNTP (server 1) IP : 129.6.15.28
SNTP (server 2) IP : 132.163.4.101
Current Time : Mon Apr 27 13:39:23 UTC 2009