Use and Care Manual

OPERATION
6
Control Panel Guide
Power Button: When the machine is in the standby mode, the display screen
will be displayed in low light LED. To start the dehumidifier, press
the power button.
Add Button: Press the Add button to increase humidity data or increase timing
data . When setting the humidity data , press the button for one time to increase
5%RH , you can set the humidity range from 10%-90% RH, and 5% RH for one step ,
Timing Button: Press the timing button ,the display screen will show the
current timing data, and then press Add button to increase the
timing data or press Minus button to decrease the timing data.
Concurrently, the display screen will light up and the unit will run in Auto mode ,
the default humidity setting data is 10% RH,and the machine will start if the humidity
condition meets the requirement of compressor operation.
Press one time to increase or decrease one hour . The timing indicator will light up after
setting. When the machine is in the standby mode, press the timing button to set the start-up
time; when the machine is running, press it to set the shutdown time. The timing setting
range is from 0 to 24 hours. If you set the timing data as “00”,it will cancel timing function ,
the timing indicator will turn off.
it will cycle as below : 10%-15%-20%-25%-30%-35%-40%-45%-50%-55%-60%-65%-70%- 75%-80%-
85%-90%-10% …When setting the timing data , press the button for one time to increase 1 hour ,
you can set the timing range from 1-24 hours ,and 1 hour for one step. it will cycle as below:
01-02-03-04-05…-23-24-00-01-02…