Instructions / Assembly

Drain outlet/External water pump inlet

Water pipe A

Water pipe B

External pump signal cable interface

Water pump signal line

Water pump power cord

Water pump

Ⅱ.External pump drainage method(not include pump,need to buy)

When it is necessary to connect an external water pump, oneend of the drainpipe is connected to the water

outlet, and theother end is connected to the water inlet of the water pump.

Note:The reserved external water pump signal input port cannot be connected to the power supply, so as

not to cause the main board ofthe product to burn out.

Vertical drainage available

Operating instructions: When using the pump drainage method, the operation is as follows.

1. The two ends of the water pipe A, one end connected to the machine drain, must be placed in place;

the other end placed in the water pump inlet, placed firmly.

2. Connect one end of the water pipe B to the water pump discharge port, and place the other end of the

water pipe in the sewer opening, or drainage sink, or water storage container; Note: the length of the water

pipe B must be within the range of the pump's head.

3. Plug one end of the pump signal line into the pump signal line interface of the machine and

assemble it in place.

4. Plug the power cord of the pump into a solid, suitable socket.Pump power on, turn on the machine

can be used to drain the water pump.