CONTENT CAUTIONS 1 PRODUCT DESCRIPTION 2 OPERATION 3 WATER TANK & DRAINAGE 4 MAINTENANCE 5 TROUBLE SHOOTING 6 STORAGE & DISPOSAL 7
CAUTIONS Please read this manual carefully before operating and keep it for further reference! If you have any questions, please contact us at support@bublue.us for help. ● Separate and count all parts and hardware. ● Read through each step carefully and follow the proper order. ● If possible, assemble the unit near where it will be placed in use, to avoid unnecessary moving. ● Always place the unit on a flat, steady and stable surface.
PRODUCT DESCRIPTION The dehumidifier is used to remove excessive moisture from the air. The resulting reduction in relative humidity protects buildings and their contents from the adverse effects of excess humidity. 2.
PRODUCT DESCRIPTION 2.
OPERATION ION LOCK SPEED MINUS ADD TIMER MODE POWER 3.1 BUTTONS POWER POWER Press this button to turn the unit on/ off. The“POWER” buttonr will light up when the unit is on, and the default settings for fan speed and humidity level are: high and 50%. MODE MODE There are three mode options: Intelligent-Continuous-Sleeping Intelligent mode: Both target humidity level and fan speed are adjustable.
OPERATION SPEED SPEED There are two fan speed options: High-Low. Press this button to switch between the speeds. The “SPEED” button will appear red when the fan speed is high, and appear green when the fan speed is low. Under continuous mode, sleeping mode, or defrosting period, the fan speed is not adjustable. LOCK LOCK A long press of this button will turn on/off the child-lock function. All buttons are locked and unresponsive to any pressing, and the “LOCK” button appears lit.
WATER TANK & DRAINAGE 1. Water Tank Full Alarm ● ● When the tank is full, the Water Tank Full Indicator lights up and the unit beeps for five times (will not beep if in Sleeping mode). The compressor and fan automatically shut down and all the functions freeze until the tank is emptied and back in the right position. 2. Empty the tank ● ● ● Grab the notch at the two sides of the tank and pull it out with both hands carefully. Empty the water. Put the water tank back in position.
MAINTENANCE 5.1 PRECAUTIONS ● Do not discard water tank magnets and plastic rivets. Otherwise, the appliance will not automatically stop operating when the water tank is full, and the condensate will overflow and damage the floor of the room. ● Make sure to drain the water tank thoroughly and put the water tank back in place, otherwise the dehumidifier cannot function. ● If the tank is dirty, wash it with cool/warm water.
MAINTENANCE 5.3. LOCATION 1. Place the appliance on a firm and horizontal surface in an area with at least 8 inches of free space around it to allow for proper air circulation. 2. Never install the appliance at a place that could be subject to: ● Heat sources such as radiators, heat registers, stoves or other products that produce heat.
TROUBLE SHOOTING 1. Functioning Temp. 41°F ≤ Ambient Temp. ≤ 95°F When the ambient temp is lower or higher than the functioning temp, the dehumidifier stops functioning. When 41°F ≤ Ambient temp. ≤ 61°F, the compressor automatically defrosts at intervals; during defrosting, the compressor stops and the fan keeps running. 2.
STORAGE & DISPOSAL 7.1 STORAGE If you are not going to use the appliance for an extended period of time (more than a few weeks), it is best to clean and dry it completely before preserving the appliance in a ventilating, dry, corrosive gas-free, and safe indoor space. The appliance must be kept in an upright position when in storage. Note: In order to avoid the damage of parts and mold, the carburetor in the device must be dried. Take it out and leave it in a ventilated place for a few days to dry.
