Use and Care Manual

9
It can be set up to continuous drainage by doing the following:
1. Open the front cover, remove the tank, and drain the water in
the tank.
2. Remove the plug and install the included drain pipe to the
connector, direct the pipe to the desired area before operating the
machine. See the pictures below.
3. Make sure the water tank and drain pipe are not blocked, close
the front panel.
4. When you do not use continuous drainage and turn to use water
tank again, just use the plug to stop the water outflow from the
connector.
 WARNING: Do not block the drainage hose. The end of the drainage
pipe should not be higher than the outlet hole. If the drainage
Continuous drainage pipe