Use and Care Manual

10
pipe end is higher than the outlet hole, water will not drain
properly and could damage components of the unit.
7.MACHINE SETUP AND OPERATION
7.1 Button Function
(1)
Press this button in the power-on state, screen light will be on, the
machine automatically goes to continuous mode, display screen shows
environmental humidity, the compressor will be on after the fan runs for 3
seconds; press this button again, the compressor stops, display screen
shows “- -”, machine goes to standby mode, fan will run for another
minute and then stop.
(2)
Press this button while machine is powered on, until button light goes on,
press “MINUS”“ADD”to set the boot time, when the countdown is over,
fan and compressor start to work.
Press this button button while machine is running, until the button light
goes on, press “MINUS”“ADD”to set the shutdown time, when the
countdown is over, fan and compressor stop working.
Press this button for 3 seconds to show the current temperature, and it