Use and Care Manual

There is a compressor inside the machine. If there is dumping or long-distance transportation,
please stand the machine upright for more than 4 hours to allow the condensate to fully reflux,
and then turn on the machine.
When the temperature exceeds 109.4 ℉ or falls below 59℉, the refrigeration function will
automatically protect the machine from running.
1. In the power on state, when the timer is not turned on, the machine will automatically start up
after powering off and then on, without pressing the standby button.
2. After normal shutdown, if there is a power outage or continuous power outage, the last
working mode will be remembered.
Preparation before installation Drainage method
Tip: Please check if the accessories are complete before installation.
Accessories List
Window isolation panel
Plate-A
Plate-B
Plate-C
Duck billed adapter
flat washer*2
Heat discharge pipe
Screw*2
screw arbor*2
sponge*2
drainage pipe
pipe joint
butterfly nut*2
remote
control
Usage suggestions:
Drainage steps:
Middle
drainage outlet
Middle
drainage outlet
drain-pipe
rubber
stopper
Waterstop
knob
rubber
stopper
Waterstop
knob
Drainage pipe
Lower
drainage hole
When operating in cool mode, manual drainage is generally not required, but when operating in
high temperature and high humidity environments, there may be a situation of water full, which
requires manual or continuous drainage.
When operating for a long time in dehumidify mode, it is necessary to connect a drainage pipe
for drainage. The drainage pipe can be connected to the middle or lower drainage outlet. It is
recommended to connect to the middle drainage outlet.
When operating for a long time in heating mode, it is necessary to connect a drainage pipe for
drainage, and connect the drainage pipe to the drainage outlet.
Regardless of the mode in which the machine operates, when the water tray is detected to be full,
the buzzer will sound and the screen will display "FU" to remind you to drain. At this time, it is
necessary to open the lower drain outlet for drainage.
After the water is completely removed and the compressor stops running for 3 minutes, the air
conditioner will resume operation.
1. Cut off the power and move the machine to the appropriate position.
2. Prepare a slightly shallow plate and place it near the lower drain or move the machine to the
floor drain.
3. Rotate counterclockwise to remove the water stop button on the lower drainage outlet, pull
out the rubber plug, and water will automatically flow out of the drainage hole. In order to drain
the water more thoroughly, the machine can be slightly tilted back (see Figure FIG1).
4.After draining the water, reverse the process and install the rubber plug and water stop knob.
Attention: When cooling at high temperatures and high humidity, if you want to avoid shutting
down when water is full, you can connect the drainage pipe to the drainage outlet (it is
recommended to lower the drainage outlet) for continuous drainage to ensure that the drainage
pipe runs smoothly straight down. (See Figure FIG2).