Use and Care Manual

The machine has an automatic defrosting function, which automatically detects the tempera-
ture and determines whether defrosting is needed during operation, ensuring that the machine
still has good heating performance even in low ambient temperatures.
Note: This key is invalid in air supply and dehumidification mode.
Before cleaning the air conditioner, it must be turned off and the power must be cut off,
otherwise there is a risk of electric shock.
Do not rinse the air conditioner with water, or there will be a risk of electric shock.
Do not use volatile liquids (such as diluents or gasoline) to clean the machine, otherwise it will
damage the appearance of the machine.
Cleaning the shell: When there is dust on the surface of the shell, please use a soft towel to wipe
it off; When the shell is dirty (such as oil), please wipe it with a neutral cleaning agent. Cleaning
the grille: You can use a vacuum cleaner or a soft bristled brush.
1. Remove the filter frame
Buckle out the rear filter frame to the side as shown in the picture; Then remove the side filter
frame from the other side.
2. Clean the filter frame
Use a vacuum cleaner or clean the filter frame with clean water. When the filter frame is dirty
(such as oil), it can be cleaned with warm water dissolved in neutral detergent, and then dried in
a cool place
Remove the pipe from the air conditioner and then clean it (using the same cleaning method as
the filter frame), air dry and then reinstall it.
Attention:
It is recommended to clean the filter frame every 20 days of use. If used in a dusty environment,
the cleaning frequency of the filter frame should be increased.
Do not dry the filter frame with fire or a hair dryer, as it may deform or catch fire.
3. Install the filter frame
After cleaning and drying the filter, reinstall it into the machine.
This machine has anti freezing protection function. When the machine is working, it will
automatically detect the temperature and determine whether the anti freezing function needs
to be activated. This ensures that the machine still has good refrigeration performance when the
ambient temperature is low.
When the machine detects that the water level in the water tray has reached the preset height,
the compressor, motor, and water throwing motor stop working. The machine emits 10 alarm
sounds, and the screen shows "FU", and the machine stops working.
After drainage, the machine returns to the state before it is full of water.
During the operation of the machine, if any operation causes the compressor to stop working. At
this time, the machine automatically switches to the protection function of stopping the
compressor for 3 minutes before restarting, which means the compressor will not start again
within 3 minutes, and other functions have outputs.
The compressor will run for at least 3 minutes after each start before stopping operation (except
for shutdown).
Before using the remote control, please install two AAA (1.5V) batteries correctly in the remote
control battery compartment
1. Align the signal transmitter with the signal receiving window on the air conditioner during use.
2.The distance between the signal transmitter and receiver window should generally be within 6
meters, and there should be no obstacles.
3. In rooms equipped with electronic start type fluorescent lamps, conversion type fluorescent
lamps, or wireless telephones, the signal is easily disturbed. The remote control should be as close
to the air conditioner as possible.
4.When not using the remote control for a long time, it is recommended to remove the battery from
the remote control.
OTHER FUNCTIONS Cleaning and maintenance
Defrost Warning
Clean the filter frame
Clean the heat discharge pipe
Clean the shell and grille
Anti freezing protection
Auto water full protection
Precautions for using remote control
Compressor shutdown/start protection
Preparation for using the remote control
3
Rear filter frame Side filter frame
If there is any problem,
pls contact us:
[e-mail]