Use and Care Manual

Install window isolation panels
1.After threading the screw through the hole on the isolation plate A, place a flat
gasket on the screw and tighten the nut. Be careful not to hold the nut to the bottom,
leaving a 2-3mm gap.
4. Adjust the position of plates A and C on board B through the sliding groove on
board B to reach the required length. Then, tighten the butterfly nut clockwise to the
end to firmly fix the relative positions of plates A, B, and C.
5.Install the duckbill shaped adapter with the installed heat pipe onto the window
isolation plate A, installation steps
(1)Insert the duckbill shaped adapter into the runway shaped hole on board A
(2)Tighten the duckbill adapter to the window isolation plate A with screws
2. After threading the screw through the hole on the isolation plate C, place a flat
gasket on the screw and tighten the nut. Be careful not to tighten the nut to the
bottom, leaving a 2-3mm gap.
3. Install the window isolation plates A and C, which were installed in steps 1 and 2,
from both ends of the window isolation plate B. When installing, be sure to align the
fixing plates on the screws with the sliding grooves of the B plate and insert them.
wing nut
wing nut
（Installation process diagram）
Open windows
up and down
Open
windows
left
and
right
6.Install the matched window isolation panel on the window frame, which can be
installed horizontally or vertically
（Schematic diagram after installation is completed）
Duck billed
adapter
Flat gasket
Flat gasket
screw
screw
Plate-A
Plate-A
Plate-B
Fixed piece
Chute
Fixed piece
Clockwise
direction
Clockwise
direction
If there is any problem,
pls contact us:
[e-mail]