Use and Care Manual

07 08
Matters Needing Attention Common troubleshooting
◆ Keep the machine in an upright position, ensure that there is at least 25cm
space distance around the machine;
◆ After transportation or tilting, the machine needs to stand for 2 hours before it
can be connected to the power supply;
◆ The air inlet and outlet shall not be blocked by other objects, so as not to affect
the performance of the product;
◆ Before moving the machine, please turn off the machine and cut off the power,
and then empty the water in the tank before moving;
◆ It is strictly forbidden to use bad or flammable detergents to clean the machine;
◆ When the machine fails, please shut down and cut off the power first;
◆ Must use a three-core socket power supply with ground wire;
◆ If the power cord is damaged, in order to avoid danger, it must be replaced by
professionals from the manufacturer, its maintenance department or similar
departments;
◆ If the machine is not used for a long time, please turn off the power and unplug
the power cord, drain the water in the water tank and dry the water tank, clean the
air filter, and store it in a cool and dry place;
◆ After 3-6 months of use of the air filter, it is recommended to clean it.
Warm Tips
It is necessary to prevent the drainage pipeline from freezing in cold environment
Symptom
The machine
does not work
Noisy
Analysis of possible causes Processing method
The wind wheel does not
rotate or the air output is
small
1. The machine is placed uneven or the
ground is uneven to introduce vibration
2. The water full indicator light is on
(the water tank is full or the water tank
is not placed in place)
3. The humidity of the room is lower
than the humidity setting value of the
machine
1. The air filter is too dirty to cause poor
air inlet or foreign objects to block the
air outlet
2. The doors and windows are not closed
3. The room temperature is lower than
5°C or the room humidity is low
1.Resonance caused by uneven machine
placement or uneven ground
2.The air filter is blocked
1.The wind wheel is stuck
2.The air filter is blocked
3. Compressor starting period
1.Check the power supply of the
socket to ensure that there is
power
2. Drain the water in the tank or
replace the tank to ensure that it is
in place
3. Reset the humidity setting value of
the machine to ensure that it is lower
than the humidity of the room
1.Clean the air filter or clean up
foreign matter at the air outlet
2.Close the doors and windows
3. This is a normal phenomenon
1.Place the machine on the
horizontal ground
2. Clean the air filter
1.Reassemble the wind wheel or
remove foreign objects
2.Clean the air filter
3. The compressor will disappear
by itself in a few minutes after
starting the work
The machine does not
dehumidify or has poor
dehumidification effect
If there is any problem, pls
feel free contact us:
[e-mail]