Use and Care Manual

9
A. Remove the cover plate from the right side B. Remove the wire connectors from the power
bottom of the appliance by removing the three cord. The power cord may be discarded.
screws, as shown above.
C. Take the new cover plate, supplied in the hardware bag. Punch out the 7/8" (22.2mm) hole and install
a box connector through, into the junction box. Snap the box connector clamp onto the supply wires.
D. Using the wire connectors, connect the ground green wires (G), the common white wires (N)
together, then the hot black wires (L) and then the refer to Figure 3.
E. Re-install the cover plate using the three screws, as shown in Figure 1.
Logset / Crystal / Pebble Ember Installation
(NOTE:Please make the installation according to the embers which you bought or selected.)
A. Glass front must be removed and the appliance must be mounted in its final location
before the logset / crystal / pebble embers are installed.
B. If your fireplace come with logset, you do not need to do anything, just use as it is. Figure 1.
C. If your fireplace come with Crystals and Pebbles:
CLEAN CRYSTAL or PEBBLE MEDIA: Crystal or pebbles media may have a fine oil residue
that needs to be cleaned prior to installation. Clean the them with mild dish soap, drain, rinse
thoroughly and dry before placing into the tray.
D. Place the plastic tray ( I ) to the fireplace designed place.Then carefully place crystal or pebbles
embers into the bottom tray on the front of the appliance as illustrated. Apply an even layer
from side to side. Figure 2, Figure 3.